Planet XGS3-24042 - Page 112

12-4
2. Add physical ports to the port group
Command
Explanation
Port Mode
port-group <port-group-number> mode
{active | passive | on}
no port-group
Add the ports to the port group and set their
mode.
3. Enter port-channel configuration mode.
Command
Explanation
Global Mode
interface port-channel
<port-channel-number>
Enter port-channel configuration mode.
4. Set load-balance method for Port-group
Command
Explanation
Aggregation port configuration mode
load-balance {dst-src-mac | dst-src-ip |
dst-src-mac-ip}
Set load-balance for switch, it takes effect
on port-group and ECMP function at the
same time.
5. Set the system priority of LACP protocol
Command
Explanation
Global mode
lacp system-priority <system-priority>
no lacp system-priority
Set the system priority of LACP protocol,
the no command restores the default value.
6. Set the port priority of the current port in LACP protocol
Command
Explanation
Port mode
lacp port-priority <port-priority>
no lacp port-priority
Set the port priority in LACP protocol. The
no command restores the default value.
7. Set the timeout mode of the current port in LACP protocol
Command
Explanation
Port mode
lacp timeout {short | long}
no lacp timeout
Set the timeout mode in LACP protocol. The
no command restores the default value.