Planet XGS3-24042 - Page 209

22-46
3. Clear dynamic ARP
4. Clear the statistic information of ARP messages
1. Configure static ARP
Command
Explanation
VLAN Interface Mode
arp <ip_address> <mac_address>
{interface [ethernet] <portName>}
no arp <ip_address>
Configures a
static ARP entry; the no
command deletes a ARP entry of the
specified IP address.
2. Configure proxy ARP
3. Clear dynamic ARP
Command
Explanation
Admin mode
clear arp-cache
The command clear arp-cache
clears the
content of current ARP table, but it does not
clear the current static ARP table.
4. Clear the statistic information of ARP message
Command
Explanation
Admin mode
clear arp traffic
Clear the statistic information of ARP
messages of the switch.
Command
Explanation
VLAN Interface Mode
ip proxy-arp
no ip proxy-arp
Enables the proxy ARP function for Ethernet
ports: the no command disables the proxy
ARP.