2-3
■ 10/100/1000Base-T and SFP interfaces
LED Color Function
LNK/ACT
Red
Lights to indicate the link through that port is successfully established
Blink to indicate that the switch is actively sending or receiving data over th
port.
Green
Lights to indicate the link through that port is successfully established
speed
Blink to
indicate that the switch is actively sending or receiving data over that
port.
No flow go through the port
XGS3-24242 LED indication
Figure 2-1-4 XGS3-24242 LED panel
■ System
LED Color Function
PWR
Lights to indicate that the Switch has power.
Power is off.
SYS Green
Light to indicate that the system is operating normally.
Blink to indicate that the system is loading.
ALM
System is operating normally
RPS
Redundancy power unit is using
Redundancy power unit is off
M1-1 / M2-1
Green
Lights to indicate the 10G port is at link state
to indicate 10G port is receiving or sending the data
10G port is not at link state
M1-2 / M2-2
Green
Lights to indicate the 10G port is at link state
Blink to indicate 10G port is receiving or sending the data
10G port is not at link state, but transceiver is in place
10G port is not at link state
To Next Page
Loading...
