1-31
November 2012
Cover Feeder
Installation
COVER FEEDER INSTALLATION
E. Press down the green marks on Paper bin and load the covers.
F. Move the adjustable side guides up against the covers, until there is no clear-
ance.
G. Set up the Cover Feeder to Cover ON, the fan will start and the Cover
Feederwillprefeedtherstcovertobereadyforthesetfromthecopier.
23. Set up the Booklet maker to A4/8.5 x 11” paper size.
24. Send one A4/8.5 x 11” job to the Booklet maker system.
25. Check that the covers are correctly fed into the Booklet maker.
26. A. Set up the Cover Feeder to Cover OFF and remove all covers from the bin.
Use the Purge mode to completely empty the Cover Feeder from covers.
B. Prepare a 15mm high stack of A3/11 x 17” covers.
C. Repeat step 22 B to 22 G.
27. Set up the Booklet maker to A3/11 x 17” paper size.
28. Send one A3/11 x 17” job to the Booklet maker system.
29. Check that the covers are correctly fed into the Booklet maker.
To Next Page
Loading...
