Content and Closed Captions
Polycom, Inc. 5–5
3 Do one of the following:
— In the local interface, go to System > Admin Settings > Network >
Call Preference (select if necessary).
— In the web interface, go to Admin Settings > Network > Call
Preference.
4 Enable H.239.
5 Do one of the following:
— In the local interface, go to System > Admin Settings > Audio >
Inputs/Outputs (select if necessary).
— In the web interface, go to Admin Settings > Network > Audio.
6 Set the Content Input Level (not available on the Polycom HDX 9002 or
Polycom HDX 9001 systems).
Sending Analog and Digital Content
If you have one content input on an HDX system connected to both an analog
source (VGA) and digital source (DVI) using a break-out cable, the HDX
system gives the digital source precedence when sending content. To send
content from the analog source, disconnect both sources, wait 10 seconds, and
then reconnect the analog source only.
Configuring Content Display with People+Content IP
People+Content IP enables a presenter to show content from a computer to
other sites in a video conference using only an IP network connection. The
presenter can show PowerPoint
®
slides, video clips, spreadsheets, or any other
type of content from a computer. People+Content IP supports any computer
desktop resolution with color set to 16-bit or higher.
Before a presenter can use a computer to show content with
People+Content IP, you need to:
You cannot enable or disable H.239 while in a call.
People+Content IP is unavailable when your Security Profile is set to Maximum.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
