Networks
Polycom, Inc. 2–3
Configuring Polycom HDX System LAN Properties
To configure Polycom HDX LAN properties:
1 Do one of the following:
— In the local interface, go to System > Admin Settings > LAN
Properties (select if necessary).
— In the web interface, go to Admin Settings > LAN Properties.
2 Configure these settings on the LAN Properties screen:
Setting Description
IP Address (IPv4) Specifies how the system obtains an IP address.
• Obtain IP address automatically — Select if the
system gets an IP address from the DHCP server on the
LAN.
• Enter IP address manually — Select if the IP address
will not be assigned automatically.
Changing this setting causes the system to restart.
IP Address If the system obtains its IP address automatically, this area
displays the IP address currently assigned to the system.
If you selected Enter IP Address Manually, enter the IP
address here. Changing the IP address causes the system
to restart.
Subnet Mask Displays the subnet mask currently assigned to the system.
If the system does not automatically obtain a subnet mask,
enter one here.
Changing this setting causes the system to restart.
Default Gateway
(IPv4)
Displays the gateway currently assigned to the system.
If the system does not automatically obtain a gateway IP
address, enter one here.
Changing this setting causes the system to restart.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
