Administrator’s Guide for Polycom HDX Systems
1–12 Polycom, Inc.
To power off a Polycom HDX 4000 system, do one of the following:
• Press and hold the power button on the side of the monitor.
The monitor and the system power off.
• Press and hold the power button on the front of the system.
The monitor and the system power off.
After turning the power off in this way, wait at least 15 seconds before you
unplug the system from its power source.
Polycom HDX 4000 Systems Indicator Lights
The following figure shows the location of the power switches and indicator
lights.
The indicator light on the front of the Polycom HDX 4000 systems provides
this information:
Monitor Power
System
Monitor Camera
Indicator Light (System) Status
Off System is without power.
Steady blue light System is initializing.
System is awake.
Blinking blue light System received an IR (infrared) signal.
Steady amber light System is asleep.
Alternating blue and amber lights System is in software update mode.
System is in factory restore mode.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
