Polycom, Inc. 2-1
2
First Time Installation and
Configuration
First Time Installation and Configuration of the RealPresence Collaboration Server 800s Virtual
Edition consists of the following procedures:
1 Preparations:
— Gather Network Equipment and Address Information - get the information needed
for integrating the RealPresence Collaboration Server 800s into the local network.
— Unpack the Polycom® RealPresence Collaboration Server 800s.
— Modify the Management Network parameters on the USB memory stick.
2 Hardware Installation and Setup
— Mount the Collaboration Server in a rack.
— Connect the necessary cables.
3 First Entry Power-up and Configuration
— Power up the RealPresence Collaboration Server 800s.
— Register the RealPresence Collaboration Server 800s.
— Connect to the RealPresence Collaboration Server 800s.
— Configure the Default IP Network Service.
Preparations
Gather Network Equipment and Address Information
IP Services
The IP addresses and network parameters which enable communication between the
Polycom® RealPresence Collaboration Server 800s, its management application and the
conferencing devices are organized in two IP services:
• Management Network (Control Unit)
• Default IP Service (Conferencing Service which includes the signaling and media)
During the First Entry Configuration, the parameters of these two network services are
modified to comply with your local network settings.
Hardware
Installation
and Setup
First Entry
Power-up and
Configuration
Preparations
Preparations
Hardware
Installation
and
Setup
First Entry
Power-up and
Configuration
To Next Page
Loading...
