Polycom® RealPresence Collaboration Server 800s Getting Started Guide
2-8 Polycom, Inc.
First Entry Power-up and Configuration
There are four procedures necessary for setup of the new RealPresence Collaboration
Server. It is important that they are performed in the following sequence:
1 First-time Power-up
2 Product Registration.
3 Connection to MCU.
4 Modifying the Default IP Service Settings (Fast Configuration Wizard).
Procedure 1: First-time Power-up
To power-up for the first time using the USB memory stick:
1 Insert the USB memory stick containing the modified IP addresses in USB port on the
RealPresence Collaboration Server 800s front or back panel.
2 Press the power button on the system. The power indicators should light.
System power-up sequence may take approximately 5 minutes.
During this time, the parameters in the lan.cfg file are uploaded from the USB memory
stick to the MCU’s memory and applied during the power-up sequence.
Wait for the upload process to complete. Do not remove the USB memory stick from the
RealPresence Collaboration Server 800s until the connection with the MCU is
established and the Login screen of the Collaboration Server Web Client is displayed.
For more details, see "Procedure 3: Connection to MCU” on page 2-9.
Procedure 2: Product Registration
Before the RealPresence Collaboration Server 800s can be used, it is necessary to register the
product and the various software licenses and obtain an Activation Key.
Preparations
Hardware
Installation
and Setup
First Entry
Power-up and
Configuration
To Next Page
Loading...
