Chapter 2-First Time Installation and Configuration
Polycom, Inc. 2-7
6 In the Initial Setup Utility screen, click the LAN Configuration Utility link.
The LAN Configuration Utility dialog box opens.
7 Modify the following parameters in the utility’s dialog box using the information
supplied by your network administrator.
— Control Unit IP Address (the Management IP address for the MCU)
— Subnet Mask
— Default Router IP Address
8 Click OK.
9 Remove the USB memory stick from the PC workstation.
The USB memory stick is required for First Entry Power-up and Configuration of the MCU.
To Next Page
Loading...
