Polycom Trio Visual+

Hardware and Accessories
Polycom, Inc. 156
To enable CEC using the Web Configuration Utility:
1 Enter the IP address of the Polycom Trio 8800 system you are using to a web browser.
2 Log into the Web Configuration Utility as an administrator.
3 Go to Settings > Networked Devices > Power Saving Settings.
4 Beside Consumer Electronic Control, select Enable or Disable.
Consumer Electronics Controls (CEC) over HDMI
Parameters
The following parameters configure CEC when using HDMI.
Power-Saving
The power-saving feature automatically turns off the phone's LCD display when not in use.
You can configure power-saving options for the Polycom Trio 8500 and 8800 system including:
● Turn on power-saving during non-working days and hours
● Configure power-saving around working days and hours
● Configure an idle inactivity time after which the phone enters power-saving mode
When the phone is in power-saving mode, an LED light flashes at intervals to indicate power is on.
CEC Parameters
Template Parameter Permitted Values Change Causes Restart or
Reboot
na powerSaving.cecEnable 0 (default) - The Polycom Trio
Visual+ display behavior is
controlled only by the value set
for
powerSaving.tvStandbyM
ode
.
1 - When the Polycom Trio
system enters power-saving
mode, the Polycom Trio
Visual+ display switches to
standby mode and powers up
when the Polycom Trio system
exits power-saving mode.
By default the Polycom Trio 8500 and 8800 systems enter power-saving mode after a period of idle
time to conserve energy. However, Polycom Trio systems do not enter power-saving mode while idle
in the Bluetooth menu. To ensure the system enters power-saving mode, you must exit the Bluetooth
menu using the Home or Back key on the Bluetooth menu.