Polycom Trio Visual+ User Manual

Content
Polycom, Inc. 53
● Content sent from People+Content is sent over USB, and no network connection is needed. This is
useful for environments where guest IP access is not allowed. You can show content with
People+Content IP on a computer connected by USB to Polycom Trio to a maximum of 1080p
resolution on a Windows computer. You must use UC Software 5.4.3AA or later to share your desktop
at up to 1080p resolution using a Mac computer connected by USB to the Polycom Trio solution.
Configuring Polycom People+Content IP over USB
This following table lists parameters that configure the People+Content over USB feature.
Polycom People+Content IP
You can share content from a computer over IP using Polycom
®
Polycom
®
Desktop Software, Polycom
®
People+Content IP (PPCIP), and Polycom
®
Polycom
®
Mobile Software. Sharing content with Polycom
People+Content IP from a computer connected over IP supports 1080p resolution with about five frames
per second on the Polycom Visual+ monitor. The computer and Polycom Trio solution must be able to
communicate on the same IP network and you must pair your Polycom software application with the
Polycom Trio system.
When Polycom Trio is registered with Skype for Business, you can use these applications to share content
only to a local monitor. You cannot share content from a Polycom Trio system over a Skype for Business
call. For instructions, see the Polycom Trio - User Guide at Polycom Trio on Polycom Support.
Configuring Polycom People+Content IP for Polycom Trio Solution
The following table lists parameters that configure content sharing with the Polycom Trio solution.
Important: The default port used by Group Paging when enabled ptt.pageMode.enable="1"
conflicts with the UDP port 5001 used by Polycom
®
People+Content™ on the Polycom Trio system.
Since the port used by People+Content is fixed and cannot be configured, configure one of two
workarounds:
• Configure a different port for Group Paging using parameter
ptt.port or
• Disable People+Content IP using parameter
content.ppcipServer.enabled="0" .
Polycom People+Content Content Sharing Parameters
Parameter
Temp l at e
Permitted Values
feature.usb.device.content
1 (default) - Enable content sharing using the People+Content IP application
on a computer connected by USB to Polycom Trio solution.
0 - Disable content sharing using the People+Content IP application on a
computer connected by USB to Polycom Trio solution.

Polycom Trio Visual+ Specifications

General

Brand	Polycom
Model	Trio Visual+
Category	Conference System
Language	English