POSEIDON SE7EN+ - Dive Logs; Chapter 4 Page 70

Poseidon SE7EN+ User Manual Chapter 4 Page 70
The Poseidon SE7EN+ automatically creates an extensive dive log every time the system is
used for diving. If a M28 dive computer is connected, SE7EN+ log data is stored there as well.
The information stored in this log will be of signicant use to reconstruct dives and to learn
about how the rig and you behave during a dive. In general, the SE7EN will store approximately
20 hours of dive time; more if the dives were of a simple nature with uncomplicated proles.
Examples of the types of data you can review are battery status, dive time and depth. However,
the dive log contains much, much more information.
Dive logs can be downloaded, viewed, and analyzed using the Reef app. The Reef app further
allows you to add pictures and text from your dive sites as a complement to the dive logs and
the Reef app can be used to congure SE7EN+.
To connect to your SE7EN+ via Bluetooth you need a device that supports standard Bluetooth
communication (BLE / Bluetooth Low Energy is not supported by SE7EN+). To activate Blue-
tooth pairing mode on your SE7EN+, power it up by inserting the battery into the e-module.
Bluetooth pairing mode will remain active for 2 minutes after the battery has been inserted.
Notice that powering on SE7EN+ from the M28 or Paddle Display when the battery is already
inserted will not activate Bluetooth pairing mode. Once your SE7EN+ has been paired with
your device it will be possible to connect to the SE7EN+ regardless of power up method as
soon as pre-dive test #32 has completed successfully.
Dive logs