power automation PA 8000 EL - Page 108

Q
Qualification
electrician ............................12
requirements .........................12
technician ............................12
Unauthorized person ...................12
Qualified personnel .......................12
R
Relay
"CNC Ready" .........................58
"Power ok" ...........................57
RF noise ...............................80
RMA form ..............................99
RMA-number ............................98
S
Safety devices ...........................17
Schematic
CNC ready relay .......................82
Digital I/O wiring .......................80
Digital input ..........................34
Digital output .........................42
Power ok relay ........................83
Safety connector ......................59
SDI ...................................47
Service ................................95
Service access ..........................79
Service Addresses .......................95
Shield .................................79
Spacing ................................76
Spare Parts .............................97
Structural requirements ....................74
System protection ........................20
T
Technician ..............................12
Temperature .........................66, 74
Training ...............................100
Troubleshooting .........................93
Type Plate ..............................24
U
Unintended use ..........................14
USB ..................................53
V
VGA ..................................51
W
Waste disposal ..........................22
Wiring
CNC ready relay .......................82
Digital I/O ............................80
Power ok relay ........................83
PA 8000 EL CNC control unit
Index
24.09.2015 | 108