PRESONUS StudioLive24.4.2 - Page 71

PreSonus StudioLive
™
24.4.2
70
Quick Start:
Level
Setting
Overview Controls Scenes,
Presets &
System
Menu
Technical
Information
Tutorials Trouble-
shooting
& Warranty
6 Connecting to a Computer
Connecting
to a
Computer
Owner’s Manual
71
Quick Start:
Level
Setting
OverviewControlsScenes,
Presets &
System
Menu
TutorialsTechnical
Information
Trouble-
shooting
& Warranty
Current Sub Section 6.0
Connecting to a Computer 6
Software
Universal Control,
Capture, and
Studio One Artist
Hookup
Hookup
Software
Universal Control,
Capture, and
Studio One Artist
Connecting
to a
Computer
6.4 Using Your StudioLive as an Audio Interface
2. The WDM Channel Mapper window will open. By
default, WDM Outputs 1 and 2 are routed to
StudioLive Channels 1 and 2. As previously
mentioned, we recommend that they be set,
instead, to Channels 25 and 26, so as not to use
input channels on your StudioLive for WDM
playback. To begin, check the box next to Output.
Click on WDM 1 (front left) and drag it down to place
it next to StudioLive 2 Track In Left. Click on WDM 2
(front right) and drag it down to place it next to
StudioLive 2 Track In Right.
Your stereo WDM playback will now be
routed directly to the main FireWire return
buttons in the 2 Track In and Monitor buses
in the StudioLive Master Section.
6.4.5 Conguring the StudioLive For Core Audio (Mac Only)
Your StudioLive can be used as the main Core Audio device for a Mac, and you
can route the main outputs of your Mac to any of its available output streams.
By default, these streams are routed to Channels 1 and 2 on your StudioLive.
The obvious limitation of this is that you will use up two input channels on
your StudioLive just for Core Audio playback. Channels 25 and 26 are available
through the FireWire Return buttons inside the 2 Track In and Monitor sections
of the StudioLive, and we recommend that you use these channels for Core
Audio playback. The following instructions will help you congure your
StudioLive to be used as the main audio playback device for your Mac.
Go to MacHD | Applications | Utilities and launch
Audio MIDI setup.
Click on the Congure Speakers button.
3. Deselect Stream 1 and select Stream 2 instead.
4. Choose Channel 25 for the left speaker and Channel
26 for the right speaker.
5. When you are nished, click Apply and then Done.