Label Stock 13
1. Connect the printer via USB and turn on the power. The Stock
Sensor Mode setting is stored on printer main board so you will
not be able to access it unless the printer is turned on and
properly communicating with the computer.
2. Go to Start - Programs - Primera Technology - PTStatus.
3. Click on the Alignment Tab (3rd tab from top).
4. Click on the Stock Sensor Mode button.
5. Select the Stock Sensor Mode by clicking on the graphic that
most closely corresponds to the stock you intend to install.
There are three sensor modes:
Die Cut (Default). If you are using standard die-cut labels that look
similar to the graphic use this setting regardless of the size of the
label. Also, use this setting for Through-hole label material where a
hole is punched through each label or a notch is cut in the side.
Reflective. Use Reflective for label material where a black
pre-printed line (black mark) on the back of the label stock indicates
the break between labels. Black marks are required on clear label
stock rolls, or label where the label waste matrix (waste) is left on
the liner. Black marks can also be used for irregular shaped labels,
circles larger than 4.6 inches or on any stock where the print starting
position can not be sensed using the label itself.
To Next Page
Loading...
Need help?
General
