14 Label Stock
Continuous. (Sensor off) If you have continuous stock with no die-
cut, reflective mark or holes, set the sensor type to Continuous. This
will turn off the stock sensor. In this mode there is no way to set the
print starting position. The printer will simply start printing the first
label and print each subsequent label immediately after that
previous one. To produce a gap between prints simply add the
desired amount of white space to the end of the label being printed.
Important Note: You must also set the Stock Sensor Position (Section 2C) so that
the sensor is sensing the correct point on the label stock.
E: SET THE OUTPUT MODE
Toggle the Output Mode to set whether or not the last label printed
will be presented or left inside the printer. To adjust
the output mode, open the PTStatus program. PTStatus
automatically installs with your printer driver and can be accessed
through the printer driver or as program that is accessible in the
same manner as all other programs.
1. Connect the printer via USB and turn on the power. The Output
Mode Setting is stored on printer main board so you will not be
able to access it unless the printer is turned on and properly
communicating with the computer.
2. Go to Start - Programs - Primera Technology - PTStatus.
3. Click on the Alignment Tab (3rd tab from top).
4. Click on the Output Mode button.
5. Select the Output Mode by clicking on the corresponding
graphic.
To Next Page
Loading...
Need help?
General
