Printing from a PC 35
TOF. Decrease the Top of form by 10. This will cause the printer
to start printing before the label and ensure a fully printed label.
Note: It is best to over bleed as little as possible to avoid excess ink on the label
backing. Also, over bleeding too much will cause the printer to skip labels.
This is because the printer stops printing too late to sense the next label.
G. PRINTER DRIVER SETTINGS
Once the printer driver has been successfully installed, you will
need to setup the driver with the appropriate print options. Refer to
the following steps to change or verify your default printer driver
preferences. These settings will apply to all new designs created in
BarTender or other programs after the preferences were changed.
Existing labels saved in BarTender will not be affected since the
preferences are saved with the label. To change these preferences
you will have to change printer preferences through BarTender.
(File Menu - Printer Settings)
Actual Label Stock
Size = 2” x 2”
Over Bleed Page Size
2.1” x 2.1” (.1 Inch)
Decrease TOF by 10
Decrease Left Margin
Offset by 12
1
To Next Page
Loading...
Need help?
General
