Label Stock 15
There are two different output modes:
Present labels - Yes (Default). This setting will cause the printer to
feed the last label printed forward so that it and the previously
printed labels can be torn off using the tear bar. If no other jobs are
sent to the printer within one second after the last label has printed,
the last printed label will present for tear off.
Present labels - No (Use with Rewinder). In this mode the label
stock does not move after the last label is printed. This means that
part of the last label printed is still in the printer. This should be
used only if you have a label rewinder attached. To retrieve the final
label you must press the Load/Feed button on the printer control
panel.
To Next Page
Loading...
Need help?
General
