Cube
22
Revision 10 EN - 03/2021
11 Displays on the device
Absorber temperature
Bluetooth connection
active/inactive
Laser power in Watt
Status message
Charge status
Fig. 11.1: Displays on the device
11.1 Status messages
Status message Meaning
Waiting for laser beam The device is ready for operation, the laser can be turned on.
Check temp. The temperature gradient (change in the absorber temperature/time)
is checked. Please wait until the message disappears. Thereafter, the
device is ready to measure again.
Thermalize The thermalization time allows for a uniform temperature distribution
in the absorber. Afterwards, the temperature is measured.
Finished The measurement is completed.
Tab. 11.1: Status messages
To Next Page
Loading...
Need help?
General
