Cube
9
Revision 10 EN - 03/2021
• Install safety switches or emergency safety mechanisms that allow the laser to be
switched off immediately.
• Use suitable beam guidance and beam absorber elements which do not emit any
hazardous substances when irradiated.
• Wear safety goggles adapted to the power, power density, laser wave length and
operating mode of the laser beam source in use.
• Wear suitable protective clothing or protective gloves if necessary.
• If possible, also protect yourself from direct laser radiation and scattered radiation
by using separating protective devices that block or attenuate the radiation.
Employing qualified personnel
The device may only be operated by qualified personnel. The qualified personnel must
have been instructed in the installation and operation of the device and must have a
basic understanding of working with high-power lasers, beam guiding systems and
focusing units.
Conversions and modifications
The device may not be modified in terms of design or safety without the express con-
sent of the manufacturer. The same applies to unauthorised opening, dismantling and
repair. The removal of covers is only permitted within the scope of the intended use.
Liability disclaimer
Manufacturer and distributor exclude any liability for damages and injuries which are
direct or indirect consequences of using the device not as intended or modifying the
device or the associated software without authorization.
To Next Page
Loading...
Need help?
General
