Prodigy Autocode User Manual

Owner’s Manual
AutoCode
®
Blood Glucose Meter
22
Setup Steps
The Prodigy AutoCode
®
meter has several different
settings that may need to be adjusted before use.
You should check the time and date each time the bat-
teries are replaced.
STEP 1: Insert the Batteries
Open the battery cover located on the back of the
meter. Insert two (2) AAA Alkaline batteries and
align them properly. The meter will turn on and
enter Setting Mode.
STEP 2: Enter Setting Mode
If your meter is off, press the “SET” button located
in the battery compartment. The meter will enter setting
mode.
Voice Speaks: “Your meter is on.
Please wait. Setting mode. English.”
STEP 3: Select Language
The language option appears rst with “L-1” on the
LCD. “L-1” indicates the default language (English);
“L-2” indicates the second language (Spanish); “L-3”
indicates the third language (French); and “L-4”
indicates the fourth language (Arabic). See gure 6.

Prodigy Autocode Specifications

General

Measurement Range	20-600 mg/dL
Sample Size	0.6 µL
Test Time	6 seconds
Coding	No Coding Required
Battery Type	2 x AAA batteries
Automatic Shutoff	2 minutes
Data Port	USB
Operating Conditions	50-104°F (10-40°C)
Memory Capacity	Up to 450 test results