Prodigy Autocode - Applying Blood to the Test Strip

Owner’s Manual
AutoCode
®
Blood Glucose Meter
42
Figure 31
Figure 32
Applying Blood to the Test Strip
STEP 1: Insert the Test Strip Insert a
test strip with the contact bar entering
the test strip slot rst. Push the test strip
in as far as it will go without bending
it. The meter will turn on automatically.
See Figure 31.
Voice Speaks: “Your meter is on.
Please wait. Please apply blood into
the test strip.”
STEP 2: Apply Blood Sample
When the meter shows “ ”, apply
blood to the open absorbent
channel of the test strip where it
will be drawn into the test strip.
See Figure 32.
If the test strip conrmation window
is full, you will hear a beep.
Voice Speaks: “Testing.”