Prodigy Autocode User Manual

Owner’s Manual
AutoCode
®
Blood Glucose Meter
If “HI” appears on your meter screen, this
could be a result of severe hyperglycemia
(results higher than 600 mg/dL). Retest
your blood glucose. If “HI” appears again,
contact your healthcare professional
immediately. See Figure 40.
Repeated Unexpected Test Results
If you continue to get unexpected test results, check
your blood glucose monitoring system by performing
a control solution test. Refer to “Performing a Control
Solution Test” section in this manual.
Unusual Red Blood Cell Count
A hematocrit range (percentage of red blood cells in the
blood) that is extremely high (above 60%) or low (below
20%) can also cause false readings.
68
Figure 40

Prodigy Autocode Specifications

General

Measurement Range	20-600 mg/dL
Sample Size	0.6 µL
Test Time	6 seconds
Coding	No Coding Required
Battery Type	2 x AAA batteries
Automatic Shutoff	2 minutes
Data Port	USB
Operating Conditions	50-104°F (10-40°C)
Memory Capacity	Up to 450 test results