25
Parameters | Sectors
User Manual | Agrónic 2500
SECTOR PARAMETERS
Sector 01
Meter No.: 01
Sector 01
Expected flow: 015.50 m3/h
Flow detector
Input No.: 00000
Sector 01
Sector area: 000000 m2
Crop: 00000000
Coe. corrector: 1.00
Sector 01
Text: abcdefghi
N. of meter (0 ... 10): meter sensor number assigned to
the sector. If irrigation is by volume, the meter must be
assigned.
Planned flow (000.00 ... 655.35): it is the flow consumed
by the sector through drip emitters, sprinklers, etc. It is
used to distribute the irrigation and fertilizer volumes
in the histories and totals of the sectors that irrigate at
the same time.
Flow detector. Input: each sector can have a digital
sensor to detect the passage of flow. This sensor
generates record 60 in the following cases: when
the sector is activated and no water passes or when
the sector is stopped and water passes. The delay
time before registration is configured in the installer
parameter. The status of the flow detector is shown
in the sector query. This parameter configures which
digital input the sensor is connected to.
For input coding, see ‘6 Input and output coding’.
Area of sector (000000 ... 999999 m
2
): area that will
irrigate the sector (1 ha=10000 m2). The sector area is
used when irrigating by m3/ha and hh:mm/ha.
Crop: type of crop that the sector irrigates. It is used for
mass programming and only with VEGGA.
Coe. corrector (0.00 ... 1.00 ... 2.55): irrigation correc-
tion coeicient. It is only used if the program where
the irrigation sector is configured is by m3/ha. The
program irrigation amount is multiplied by this coef-
ficient. If it is le at 1.00 the value is not modified. If
a program has more than one sector configured, the
coeicient of the first is used.
Text (0 ... 9 characters): identifying text of the sector.
The Communications Query
section is detailed in the
Communications Manual
r1754
Video tutorial
available for
this section
See Communications Manual
To Next Page
Loading...
Need help?
General
