Progrés Agronic 2500 User Manual

32
User Manual | Agrónic 2500
Parameters | Determining factors
5.6.5 Modify irrigation – Modify fertilizer
Increase or decrease the irrigation or fertilizer units
depending on the value of the determining factor.
The modification is made when the program is started.
Origin: digital sensor
% to modify (-100 ... 000 ... 100): if the determining
factor is activated when the program starts, it modifies
the irrigation or fertilizer by the % indicated here.
Origin: analog sensor
Previous hours (000 ... 255 h): the number of hours
before the start of the program that the determining
factor will be integrate. If le at 0, it is not integrated,
it uses the last sensor reading. The integration value
increases every 10 minutes.
Reference: start and end values of the integration line.
% to modify (-100 ... 000 ... 100): start and end values of
the irrigation or fertilizer modification line.
Origin: meter sensor, total
The accumulation of a meter sensor can be the rain
fallen over a certain time.
Previous hours (000 ... 255 h): the last hours total is used
to calculate the determining factor. Here, configure
the number of hours back that should be taken into
account.
Reference: start and end values of the integration line.
Values are in liters.
% to modify (-100 ... 000 ... 100): start and end values of
the irrigation or fertilizer modification line.
DETERMINING FACTOR PARAMETERS
Determining factor: 01 Type: modify Irrigation
Origin: digital sensor
Digital sensor No.: 02
% to modify: +025%
Origin: analog sensor
Analog sensor No.: 02
Previous hours: 048
Point 1:
Reference: 3500 W/m2
% to modify: -010%
Point 2:
Reference: 9000 W/m2
% to modify: +050%
Origin: meter sensor
Meter sensor No.: 01
Previous hours: 048
Point 1:
Reference: 001 L/m2
% to modify: +000%
Point 2:
Reference: 024 L/m2
% to modify: – 080%

Progrés Agronic 2500 Specifications

General

Brand	Progrés
Model	Agronic 2500
Category	Farm Equipment
Language	English