33
Parameters | Determining factors
User Manual | Agrónic 2500
5.6.6 End due to rain
It does not allow irrigation to start, or stops it if it is
irrigating, when the rain reaches a certain amount.
The origin is always a meter sensor.
Previous hours (000 ... 255 h): the last hours total is used
to calculate the determining factor. Here, configure
the number of hours back that should be taken into
account.
Reference: amount of total water to stop irrigation.
When a program starts by a manual command, this de-
termining factor will not be taken into account.
DETERMINING FACTOR PARAMETERS
Determining factor: 18 Type: end due to rain
Origin: meter sensor
Meter sensor No.: 03
Previous hours: 024
Reference: 005 L/m2