Beta Draft Confidential
Status & Control Page
Professional Series Network Thermostat Configuration Guide, Release 3.0 3-13
Part No. 600-01000-200, Rev. 2
High Humidity
(NT150e/h and
NT160e/h only)
Displays the current status of the High Humidity alarm condition. The
relative humidity has risen above a pre-programmed limit. After this alarm
occurs, you must repair the condition which caused the humidity to rise
above the configured limit before resetting this alarm. (See General Settings
(Alarms and Alerts Pending) Page (page 3-14).)
OK – No High Humidity alarm exists.
Alert! – The humidity monitored within the thermostat has risen above
the pre-set high humidity threshold.
Filter Change Displays a reminder that the time interval between HVAC filter changes has
expired. The air filter(s) should be cleaned or replaced. You should change
the filter and then reset this timer. (See General Settings Page (page 3-14).)
OK – No filter change is required.
Required! – The HVAC filters require changing or cleaning.
Table 3-1 Thermostat Status Field Descriptions (Continued)
Field Description
To Next Page
