protech PA-6225 - Page 100

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 93
area, the printing area width is automatically set to (horizontal printable area
- horizontal starting position).
 If (vertical starting position + printing area height) exceeds the printable
area, the printing area height is automatically set to (vertical printable area -
vertical starting position).
ESC \ nL nH
[Name]
Set relative print position.
[Format]
ASCII ESC \ nL nH
Hex. 1B 5C nL nH
Decimal 27 92 nL nH
[Range]
0 ≤ (nL + nH x 256) ≤ 65535 (0 ≤ nL 255, 0 ≤ nH ≤ 255)
[Description]
Specifies the next print starting position with a relative position based on the
current position. This sets the position from the current position to [(nL + nH x
256) x basic calculated pitch] for the next print starting position.
Specifications exceeding the print range are ignored.
ESC a n
[Name]
Select justification.
[Format]
ASCII ESC a n
Hex. 1B 61 n
Decimal 27 97 n
[Range]
0 ≤ n ≤2
Initial Value n = 0
[Description]
This command specifies position alignment for all data in one line in
standard mode, using n as follows:
n
Alignment
0
Left alignment
1
Center alignment
2
Right alignment
This command has no effect in page mode.