protech PA-6225 - Page 99

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 92
ESC V n
[Name]
Turn 90 degree clockwise rotation mode on/off
[Format]
ASCII ESC V n
Hex. 1B 56 n
Decimal 27 86 n
[Range]
0 ≤ n≤ 1, 48≤ n ≤49
Initial Value n = 0
[Description]
Specifies or cancels character 90 degree clockwise rotation.
 Underlines are not applied to characters rotated 90 degrees clockwise
even when ESC !,ESC - or FS - commands are given.
 If 90 degree clockwise rotation is specified, double-wide and double-tall
commands in the 90 rotation mode enlarges characters in the opposite
directions to double-wide and double-tall commands.
 This command only affects printing in standard mode.
 In page mode, this command is only effective for the setting.
 This command is effective for ANK and Chinese characters.
n
Function
0, 48
1, 49
ESC W xL xH yL yH dxL dxH dyL dyH
[Name]
Set printing area in page mode
[Format]
ASCII ESC W xL xH yL yH dxL dxH dyL dyH
Hex. 1B 57 xL xH yL yH dxL dxH dyL dyH
Decimal 27 87 xL xH yL yH dxL dxH dyL dyH
[Range]
0 ≤ xL, xH, yL, yH, dxL, dxH, dyL, dyH ≤ 255
However, this excludes dxL = dxH = 0 or dyL = dyH = 0
Initial Value xL = xH = yL = yH = 0
[Description]
Sets the print region position and size.
 Horizontal direction starting point [(xL + xH x 256) x basic calculated pitch]
 Vertical direction starting point [(yL + yH x 256) x basic calculated pitch]
 Horizontal direction length [(dxL + dxH x 256) basic calculated pitch]
 Vertical direction length = [(dyL + dyH x 256) basic calculated pitch]
 (X+Dx-1)<576 (3 inch, basic calculated pitch=1);(X+Dx-1)<432 (2 inch,
basic calculated pitch=1)
 (Y+Dy-1)<768 (basic calculated pitch=1);
 If (horizontal starting position + printing area width) exceeds the printable