protech PA-6225 - Page 98

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 91
d. ESC 3 :Set line spacing
 The following commands are effective only when in standard mode.
a. ESC W :Set print region in page mode
b. ESC T :Select character print direction in page mode
 The following commands are ignored in standard mode.
a. GS $ :Specify absolute position for character vertical direction in page
mode.
b. GS \: :Specify relative position for character vertical direction in page
mode.
 Standard mode is selected when the power is turned on, the printer is reset
or initialized (ESC @).
ESC T n
[Name]
Select print direction in page mode.
[Format]
ASCII ESC T n
Hex. 1B 54 n
Decimal 27 84 n
[Range]
0 ≤ n ≤ 3, 48 ≤ n ≤ 51
Initial Value n = 0
[Description]
Selects the character printing direction and starting point in page mode.
n
Print Direction
Starting Point
0, 48
Left to Right
Upper Left (A in the figure below)
1, 49
Bottom to Top
Lower Left (B in the figure below)
2, 50
Right to Left
Lower Right (C in the figure below)
3, 51
Top to Bottom
Upper Right (D in the figure below)