protech PA-6225 - Page 114

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 107
[Description]
Executes specified paper cut.
m
Function
0 , 48
Full cut
1 , 49
Partial cut (one point uncut)
65
Feeds paper to (cutting position + [n x basic calculated pitch])
and performs a full cut
66
Feeds paper to (cutting position + [n x basic calculated pitch])
and performs a partial cut (one point uncut)
GS W nL nH
[Name]
Set printing area width.
[Format]
ASCII GS W nL nH
Hex. 1D 57 nL nH
Decimal 29 87 nL nH
[Range]
0 ≤ nL ≤ 255, 0 ≤ nH ≤ 255
[Description]
 Sets the print region width specified by nL and nH.
 Print region width is [(nL + nH x 256) x basic calculated pitch].
 [(nL + nH x 256) x basic calculated pitch] >=24.
GS \ nL nH
[Name]
Set relative vertical print position in page mode.
[Format]
ASCII GS \ nL nH
Hex. 1D 5C nL nH
Decimal 29 92 nL nH
[Range]
0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description]
Specifies the character vertical direction position for the data expansion
starting position using the relative position based on the current point in page
mode. This sets the position moved from the current position to [(nL + nH x
256) x basic calculated pitch] for the next data expanding starting position.
 When not in page mode, this command is ignored.