protech PA-6225 - Page 85

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 78
Setting : Printer uses flags to make settings, and those settings affect the following data.
○: Enabled.
◎: Enabled only when the command is set at the beginning of a line.
●: Enabled only when data is not present in the printer buffer.
▲: Only value setting is possible.
Disabled: Parameters are processed as printable data.
Ignored: All command codes including parameters are ignored and nothing is executed.
COMMANDS DETAILS
STANDARD COMMANDS DETAILS
HT
[Name]
Horizontal tab
[Format]
ASCII HT
Hex. 09
Decimal 9
[Range]
N/A
[Description]
Moves print position to next horizontal tab position.
 This command is ignored if the next tab is not set.
 If the next tab position exceeds the print region, the print position is
moved to [print region + 1].
 The horizontal tab position is set by ESC D (Set/cancel horizontal tab
position).
 When the print position is at the [print region + 1] position and this
command is received, the current line buffer full is printed and a horizontal
tab is executed from the top of the next line.
 The initial value of the horizontal tab position is every 8 characters of Font
A (the 9th, 17th, 25th positions, etc.)
LF
[Name]
Print and line feed
[Format]
ASCII LF
Hex. 0A
Decimal 10
[Range]
N/A
[Description]
Prints the data in the print buffer and performs a line feed based on the set line
feed amount.
 After execution, makes the top of the line the next print starting position.