protech PA-6225 - Page 86

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 79
FF
[Name]
Print and recover to standard mode (in page mode)
[Format]
ASCII FF
Hex. 0C
Decimal 12
[Range]
N/A
[Description]
Prints all buffered data to the print region collectively, and then recovers to
the standard mode.
 All buffer data is deleted after printing.
 The print area set by ESC W (Set print region in page mode) is reset to
the default setting.
 No paper cut is executed.
 Sets the print position to the beginning of the next line after execution.
 This command is enabled only in page mode.
CR
[Name]
Print and carriage return
[Format]
ASCII CR
Hex. 0D
Decimal 13
[Range]
N/A
[Description]
When an automatic line feed is enabled, this command functions in the same
way as LF (print and line feed). When the automatic line feed is disabled, this
command is ignored.
 This command is ignored with serial interface models.
 Sets the print position to the beginning of the next line after execution.
CAN
[Name]
Cancel print data in page mode
[Format]
ASCII CAN
Hex. 18
Decimal 24
[Range]
N/A
[Description]
Deletes all print data in the currently set print region in page mode.
 This command is enabled only in page mode.
 Portions included in the currently set print region are also deleted, even if
previously set print region data.