protech PA-6225 - Page 89

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 82
DLE ENQ n
[Name]
Real-time request to printer.
[Format]
ASCII DLE ENQ n
Hex. 10 05 n
Decimal 16 5 n
[Range]
1 ≤ n ≤ 2
[Description]
Responds to requests n specifications from the host in real-time.
n specifications are below.
n = 1: Recover from the error and start printing from the line where the error
occurred.
n = 2: Recover from error after clearing the reception buffer and print buffer.
This command is enabled even when the printer specification is disabled by
ESC = (select peripheral devices).
DLE DC4 n m t
[Name]
Real-time output of specified pulse.
[Format]
ASCII DLE DC4 n m t
Hex. 10 14 n m t
Decimal 16 20 n m t
[Range]
n = 1
m = 0,1
1 ≤ t ≤ 8
[Description]
This outputs a signal specified by t to the connector pin specified by m.
m = 0: #2 Pin of the drawer kick connector
m = 1: #5 Pin of the drawer kick connector
On time is set to t x 100 msec; Off time is set to t x 100 msec.
ESC FF
[Name]
Print data in page mode.
[Format]
ASCII ESC FF
Hex. 1B 0C
Decimal 27 12
[Range]
N/A
[Description]
Prints all buffered data in the print area collectively in page mode.
 This command is enabled only in page mode.
 Holds the following information after printing.
a. Expanded data
b. Character print direction selection in page mode (ESC T)