protech PA-6225 - Page 92

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 85
ESC - n
[Name]
Turn underline mode on/off.
[Format]
ASCII ESC - n
Hex. 1B 2D n
Decimal 27 45 n
[Range]
0 ≤ n ≤ 2
Initial Value n = 0
[Description]
This command enables the print data following it to be printer out underlined.
The underline mode varied depending on the following values of n:
n
Function
0
Turns off underline mode
1
Turns on underline mode, set at 1-dot thick
2
Turns on underline mode, set at 2-dot thick
ESC 2
[Name]
Select default line spacing.
[Format]
ASCII ESC 2
Hex. 1B 32
Decimal 27 50
[Range]
N/A
[Description]
This command sets the default line spacing The default line spacing is
approximately 4.25 mm, which is equivalent to 34 dots.
ESC 3 n
[Name]
Set line spacing.
[Format]
ASCII ESC 3 n
Hex. 1B 33 n
Decimal 27 51 n
[Range]
0 ≤ n ≤ 255
Initial Value n = 34
[Description]
This command sets the line spacing using a following rule.
Line spacing = n x (vertical or horizontal motion units)