protech PA-6225 - Page 91

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 84
ESC $ nL nH
[Name]
Set absolute print position.
[Format]
ASCII ESC $ nL nH
Hex. 1B 24 nL nH
Decimal 27 36 nL nH
[Range]
0 ≤ (nL + nH x 256) ≤ 65535 (0 ≤ nH ≤ 255, 0 ≤ nL ≤ 255)
[Description]
This command specifies the next print starting position in reference to the left
edge of the print area. The printing start position is calculated using (nL +
nH x 256) x (vertical or horizontal motion units). Specifications exceeding the
print range are ignored.
ESC * m nL nH d1…dk
[Name]
Select bit image mode
[Format]
ASCII ESC * m nL nH d1...dk
Hex. 1B 2A m nL nH d1...dk
Decimal 27 42 m nL nH d1...dk
[Range]
m = 0,1,32,33
0 ≤ nL ≤ 255
0 ≤ nH ≤ 3
0 ≤ d ≤ 255
[Description]
Selects a bit-image mode in mode m for the number of dots specified by nL and
nH.
m = 1,33 : (nL+nH×256)<576 (3 inch);(nL+nH×256)<432 (2 inch).
m = 0,32 : (nL+nH×256)<288 (3 inch);(nL+nH×256)<216 (2 inch).
m
Mode
Number
of
Vert. Dir.
Dots
Density
of
Vert. Dir.
Dots
Density
of Hor.
Dir.
Dots
Data Count (k)
0
8 dot single
density
8
67 DPI
101 DPI
nL+nH×256
1
8 dot double
density
8
67 DPI
203 DPI
nL+nH×256
32
24 dot
single
density
24
203 DPI
101 DPI
(nL+nH×256)
×3
33
24 dot
double
density
24
203 DPI
203 DPI
(nL+nH×256)
×3