Protek 3201 - Page 62

9. ATT Level Data Setup
COMMAND + DATA(ASC CODE) + CR(0DH)
Ex.) ATT LEVEL on 18.5dB, Enter “S018.5” CR
ATT LEVEL on 0.0dB, Enter “S00.0” CR
10. COMMAND CODE(*: default set)
1) Function Mode Setup
*A0 SPECTRUM MODE
A1 BAR 160CH MODE
A2 BAR 80CH MODE
A3 BAR 40CH MODE
A4 BAR 20CH MODE
A5 BAR 10CH MODE
A6 BAR 5CH MODE
A7 DIFFERENCE MODE
A8 SINGLE MODE
A9 COUNTER MODE
Ex.) A1 CR: BAR 160CH MODE
2) Scan Mode Setup
*B MANUAL MODE
B1 CH MODE
B2 SEARCH MODE
Ex.) B1 CR: CH MODE
57
57
3) Sweep Mode Setup
*C0 FREE RUN MODE
C1 FREE SINGLE MODE
C2 NORMAL MODE
C3 SINGLE MODE
Ex.) C0 CR: FREE RUN MODE
4) CH BANK Setup
*D0 CH BANK in No 1
D1 CH BANK in No 2
D2 CH BANK in No 2
D3 CH BANK in No 3
D4 CH BANK in No 4
D5 CH BANK in No 5
D6 CH BANK in No 6
D7 CH BANK in No 7
D8 CH BANK in No 8
D9 CH BANK in No 9