Protek 3201 - RS-232 C COMMAND - Setup and Data Output; RUN;STOP Setup Commands; Level Data Output Commands; ATT Level Data Commands

P4 AUTO POWER ON
Ex.) P1 CR: AUTO POWER OFF after 10 minutes
17) RUN STOP Setup
Q0 STOP mode
Q1 RUN mode
Ex.) Q1 CR: RUN mode
18) LEVEL DATA Output Setup
*R0 LEVEL DATA Output
R1 Indicated CH LEVEL DATA Output
R2 Previous CH and DIFFERENCE LEVEL DATA Output
R3 CH DATA and CH DATA Output each time
19) A.T.T LEVEL DATA Setup
S0 ATT LEVEL DATA
Ex.) S0 12.5 CR: ATT LEVEL on 12.5dB
** Reference to ATT LEVEL DATA Setup
20) PRINTER MDOE Setup
*T0 PRINT MODE
T1 ESC/P MODE
T2 NM MODE
Ex.) T1 CR: ESC/P MODE
21) MARKER CH Setup
V0 1CH
V1 2CH
V,9FH 160CH
Ex.) V9 CR: 160CH MARKER
||
22) Each CH Setup Output
W0 MARKER CH
W1 Indicate left
W2 Current LEVEL CH
Ex.) W0 CR: Set up MARKER CH
A CR: 17CH
60
60