Protek 3201 - RS-232 C COMMAND - Setup and Output Codes; Frequency Setup Commands; Frequency Output Commands; Title and Channel Name Commands

Ex.) J1 CR: COPY input START
All the data of CH and DATA MEMORY will be outputted in HEX
** Recommend not to use this function. Special users only.
11) Frequency Setup
K0 MARKER frequency
K1 SETUP frequency
K2 DIFFERENCE STEP frequency
Ex.) K0 2000.12625 CR: MARKER frequency on 2000.12625MHz
12) Frequency Output
L0 MARKER frequency
L1 STEP frequency
L2 DIFFERENCE STEP frequency
L3 START frequency: can be operated on SEARCH MODE only
L4 STOP frequency: can be operated on SEARCH MODE only
L5 Center frequency: can be operated on MANUAL MODE only
L6 SPAN frequency: can be operated on MANUAL MODE only
L7 Current frequency
L8 COUNTER frequency: can be operated on OUTPUT MODE only
Ex.) L0 CR: MARKER frequency output
10.12625 CR: 10.12625MHz (**Reference to Frequency Output FORMAT)
13) TITLE NAME and CH NAME Setup
M0 TITLE NAME: Up to 10 characters
M1 CH NAME: Up to 5 characters (CH MODE only)
Ex.) M2 TEST2 CR: NAME of TEST2 will be Memorized on current CH
14) TITLE NAME and CH NAME Output
N0 TITLE NAME: Up to 10 characters
N1 CH NAME: Up to 5 characters (CH MODE only)
Ex.) N0 CR: TITLE NAME output
“CATV KOREA” CR: TITLE NAME
15) UP, DOWN Setup
O0 “UP KEY” one time
O1 “DOWN KEY” one time
Ex.) O1 CR: DOWN Operation
16) POWER MODE Setup
*P0 AUTO POWER OFF 5
P1 AUTO POWER OFF 10
P2 AUTO POWER OFF 20
P3 AUTO POWER OFF 30
59
59