Pulsar Nova® sound level meter user manual
Page 20
When a measurement is in progress, the overload indicator stays on until the
measurement is stopped or reset.
In some circumstances the overload and under range indicators will be shown
simultaneously. In this case the text will be abbreviated to save space.
Note: If any displayed decibel value on the Sound Level View or Leq View is below
14.0dB, the value will be replaced by dashes ('---'). These levels are typically below the
noise floor of the microphone capsule and so will only be encountered during electrical
testing.
‘Bluescreen’
Under rare circumstances, when the Nova® encounters a condition it cannot recover
from, a ‘bluescreen’ error message will show with an error code.
If this should happen to your Nova®, please make a note of the code so that the
engineers at Pulsar Instruments can diagnose your problem accurately.
After writing down the code, pressing the right key will clear the screen and the
instrument can be used as normal.
To Next Page
Loading...
Need help?
General
