PULSION PiCCO2 - EMC Requirements - Emissions

Appendix
Operator´s Manual PiCCO
2
Page
Version 3.1 E-7
4 EMC-Requirements
Table 1 – Guidance and manufacturer´s declaration – electromagnetic emissions
(EN 60601-1-2:2007; 5.2.2.1 c)
Guidance and manufacturer´s declaration – electromagnetic emissions
The PiCCO
2
is intended for use in the electromagnetic environment specified below. The customer or the user of the
PiCCO
2
should assure that it is used in such an environment.
Emissions test
Compliance
Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1
The PiCCO
2
uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B
The PiCCO
2
is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low voltage power supply
network that supplies buildings used for domestic
purposes.
Harmonic emissions
IEC61000-3-2
Class A
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
Complies