Sterling 10 Installation Manual
Page 14 RINS1413-1
4. SAFETY
SAFETY
5. A technically competent person must carry out the mains installation in accordance with national
and local electrical installation regulations.
6. Protective Earth: This equipment must be earthed / grounded.
7. Functional Earth: Provides additional interference protection of a functional purpose only.
8. Connect the unit to a single pole, un-switched, 3-Amp fused spur, using 0.75mm
2
cable. If the
Neutral cannot be positively identified, use a double-pole disconnect version.
9. Always remove/isolate the mains supply before carrying out any servicing of the panel.
10. Fuses: For continued protection against the risk of fire, replace only with the same type and
rating of fuse.
11. Ventilation: To ensure the correct airflow, always mount the unit vertically with the unit having
a clear space on all sides. It must not be covered by clothes, furnishings, boxes, etc. It must not
be mounted close to, or above, heat radiating sources.
12. On completion of wiring, use tie-wraps to prevent any loose wires causing a safety hazard.
13. The mechanical mounting of the unit must be secure enough to carry the full weight of the unit
including all batteries.
14. Batteries: Ensure that the battery terminal connections will not create an electrical short-circuit
on the case metalwork when the unit is closed. Use insulated battery lead connectors.
15. Dispose of discarded batteries as required by environmental legislation / recommendations.
16. The battery case must have a flame-retardant rating of UL94-V2/V1/V0 – IEC60950:2000.
17. Water: The equipment must be kept free from dampness, water and any other liquids. It is only
suitable for installation indoors.
C
O
M
P
L
I
A
N
C
E
To Next Page
Loading...
Need help?
General
