Pyronix STERLING 10 Installation Manual

Sterling 10 Installation Manual
RINS1413-1 Page 31
6.6.4 System Options 4 (Function 25)
Press 
This starts the function
ENTER SEQUENCE
x x x
Use keys  to  to toggle the
options on or off.
Example shows option 2 off.
ENTER SEQUENCE
x x x x
Press 
You will be returned to engineer mode.
Options:
Option Option On ( ) Option Off (
x
) (Default)
1 Abort Digi Active High Abort Digi Active Low
2 Open Digi Active High Open Digi Active Low
3
Service Timer Warning & Lockout System on
Expire
Service Timer Warning on Expire if
programmed with Function 27
4 Anti-Code Reset Enabled Anti-Code Reset Disabled
6.7 Programmable Rearms (Function 26)
Press 
This starts the function
ENTER SEQUENCE
Enter the number of rearms  to .
NOTE: Default is 0 (Continuous).
0 = Continuous
1 - 9= Number of Rearms
ENTER SEQUENCE
0
The number will save automatically.
You will be returned to engineer mode.
6.8 Service Timer (Function 27)
Press 
This starts the function
ENTER SEQUENCE
Enter the number of arm and disarm
cycles between service intervals  to
.
NOTE: Default is 0 (No timer).
Time Between Services
Arm/Disarm
Cycles Per
Day
30
Days
6
Months
12
Months
1






4






ENTER SEQUENCE
0
The number will save automatically.
You will be returned to engineer mode.

Pyronix STERLING 10 Specifications

General

Brand	Pyronix
Model	STERLING 10
Category	Control Panel
Language	English