Sterling 10 Installation Manual
Page 22 RINS1413-1
5.9 Keyswitch Arm Configuration
Function Arm Mode Default Key
|__|
0 0 = Arm Mode A
1 = Arm Mode B
2 = Arm Mode C
3 = Arm Mode D
5.10 Engineer Code NVM Reset
Place link across NVM Reset pins on PCB. Enter . Control panel will emit 3 beeps and will be returned to factory defaults.
5.11 Communicator Test
Function Toggle Outputs Key
...
= Alarm
= P.A.
= Fire
= Confirmed Alarm
= Abort
= Open/Close (Set)
5.12 Anti-Code Algorithm
Function Algorithm Default Key
|__|
0 0...8 = Algorithm
NOTE: The Anti-Code algorithm should be left at default (0).
To Next Page
Loading...
