44
4.7 ADVANCED
In this set of commands, the user can erase all the settings, import or export data files to
and from the DVR and control who can remotely access the DVR through three submenus:
Reset, Import/Export and Black/White List.
PICTURE 4-30
PICTURE 4-32
RESET
Clicking on this option will open a warning
dialogue asking you to confirm that you wish
to remove all settings and reboot the system.
You must select OK to continue with the reset
or hit CANCEL to exit without changes.
BLOCK/ALLOW LIST
From here, an authorized user can control which computer users are allowed to access the
DVR.
The Block List is used to deny access to remote computers within a certain IP address
segment.
The Allow List is used to permit access by users from select IP address segments.
EXAMPLE: You wish to block access to the DVR from computer users within the IP address
segment ranging from 196.168.000.002 to 196.168.000.004. Select the Block button and
then enter the first segment in the IP From field and the last address within the segment in
the To field. You may add additional segments before hitting Apply to save your settings and
then exiting this window.
IMPORT/EXPORT
Use this interface to export select data files
to mobile Flash drives or an external USB
drive through the backup function. Specific
data files can also be retrieved from mobile
or external storage devices and recorded
onto the DVR.
PICTURE 4-31
To Next Page
Loading...
Need help?
General
