65
VIDEO LOSS
In the event that signal is lost by one camera, others can be activated to record while
additional devices can also be triggered.
Test your settings by moving something
or someone through the grid area in the
camera’s view. Motion should not be detected
outside of this area but you should see a
yellow humanoid figure appear in the screen
once the DVR detects movement within the
grid. Removing the grid where there is a flag
or trees that frequently move in the wind will
prevent false alerts. Click on the Disk button
to save your settings before exiting the setup
process by clicking on the X button.
Schedule Tab
This is also set to be on all the time by default and it can be adjusted in the same manner as
the Schedule configuration in SECTION 4.4.
PICTURE 8-9
PICTURE 8-10
PICTURE 8-11
PICTURE 8-12
Like the Trigger tab in the Alarm Handling
section of the Sensor menu, you can select
the events that you wish to occur in the
event that a video input is lost. Both Alarms
and PTZ events can be scheduled as in the
Sensor menu above.
OTHER ALARM
In this menu you can set the DVR to alert you to a full Hard Drive, IP Conflict on the network or
a Disconnection.
You can set the response as well as at what
threshold of remaining disk space you wish to
be alerted.
Sensitivity: 6Sensitivity: 6
To Next Page
Loading...
Need help?
General
