Need help?Do you have a question about the QBot inspira and is the answer not in the manual?
General| Brand | QBot |
|---|---|
| Model | inspira |
| Category | Sewing Machine |
| Language | English |
Steps to attach drive assemblies to the frame.
Connecting and tensioning upper and lower drive wires.
Securing the drive system and mounting the QBOT.
Using templates to drill holes for the Inspira frame.
Attaching the Y-axis drive assembly for Inspira.
Connecting and tensioning the drive wire for Inspira.
Attaching the lower carriage assembly for Inspira.
Connecting the shorter and longer wires to the QBOT.
Wiring the QBOT to the QCC via various cables.
Connecting the QBOT and QCC power supplies.
Tidying wires and noting setup parameters.
Executing a test pattern to verify system functionality.
Understanding the outcome of the test pattern.
Adjusting the 'X Axis Direction' parameter for Inspira.
Adjusting a switch for Brother/Babylock machines.
Explains lights, buttons, and navigation.
Navigating designs and initiating the quilting process.
Setting the 'right-upper' and 'left-lower' corners.
Choosing to keep or alter design proportion.
Adjusting the start point and beginning the quilting.
Procedures for stopping, restarting, or ending quilting.
Resolving incorrect carriage movement during tests.
Troubleshooting 'No SD Card Detected' messages.
Addressing issues with 'sloppy' stitching paths.
To Next Page