GEM5000 Gas Analyzer
Page 89 of 102
The Units of Measurement interface allows users to select whether to operate the instrument
in metric or imperial units. The units for each parameter are displayed on the screen.
WARNING: Units of Measure are as critical as the values of the readings stored. Be certain
to verify the appropriate Units of Measure for your project prior to making a change to this
option. Changing the Units of Measure will NOT convert any existing values stored in the
instrument. To avoid confusion, download any stored readings prior to changing the Units of
Measurement.
Clicking on the Set Units button will bring up the Change Units Password box. If you must
change the units of measure please call LANDTEC’s Software Support for a password.
Upon entering the password you’ll be prompted one last time to download your data from the
instrument. If you have not downloaded your instrument press the No or Cancel buttons.
Click Yes only if you have all data from your instrument as changing the units of measure
must erase data that is in the instrument to ensure data integrity.
To Next Page
Loading...