EasyManuals Logo

Qlogic SANbox 5600 Series Installation Guide

Qlogic SANbox 5600 Series
280 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #111 background imageLoading...
Page #111 background image
5 – Diagnostics/Troubleshooting
Recovering a Switch
59096-02 C 5-15
A
5.4.7
Maintenance – Remake Filesystem
In the event of a loss of power, the switch configuration may become corrupt. The
file system on which the configuration is stored must be re-created. This option
resets the switch to the factory default values including user accounts and zoning.
Refer to Table B-9 though Table B-16 for the factory default values.
5.4.8
Maintenance – Reset Switch
This option closes the Telnet session, exits maintenance mode and reboots the
switch using the current switch configuration. All unpacked firmware image files
that reside on the switch are deleted.
5.4.9
Maintenance – Update Boot Loader
This option updates the system boot loader which loads the Linux kernel into
memory. Use this option only at the direction of your authorized maintenance
provider.
CAUTION!
If you choose the Remake Filesystem option, you will lose all
changes made to the fabric configuration that involve that switch,
such as password and zoning changes. You must then restore the
switch from an archived configuration or reconfigure the portions of
the fabric that involve the switch.

Table of Contents

Other manuals for Qlogic SANbox 5600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Qlogic SANbox 5600 Series and is the answer not in the manual?

Qlogic SANbox 5600 Series Specifications

General IconGeneral
BrandQlogic
ModelSANbox 5600 Series
CategorySwitch
LanguageEnglish

Related product manuals